Allied Data Technologies 811 Manuel d'installation télécharger pdf (Page 73)

Chapter 5: Configuring the CopperJet

-->voip set sip outboundservertransport udp <Enter>

5.18.1.13 Enable SIP tracing in the CopperJet

To enable SIP tracing in the CopperJet, please follow these steps:

• Open a telnet session to the CopperJet

Note: To open a telnet session, go to Start -> Run and type cmd and click on

OK. A DOS box will open. Now type telnet 172.19.3.1 and press Enter.

Default username and password is admin.

• Type the following commands:

-->system log enable voip pots <Enter>

Note: VoIP must be registered for using this command.

-->console enable

Quantum>log level 1 <Enter>

The trace is now started.

To stop the logging, type:

Quantum>log level 0 <Enter>

Page 71

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 85 86

Pas de commentaire

Allied Data Technologies 811 Manuel d'installation Page 73