Allied Data Technologies 811 Manuel d'installation télécharger pdf (Page 11)

Chapter 4: Before you start

4 Before you start

The following information may be required for configuring the CopperJet. If you do not

know if all the information is needed, please contact your DSL service provider before

proceding with the configuration.

4.1 IP Address Settings

The CopperJet allows the ISP to dynamically assign IP Address settings. If your ISP

requires static setting of specific IP address information, you need to receive the following

information:

• IP Address

• Subnet Mask

• Default Gateway

4.2 Name Server Information

The CopperJet allows the ISP to dynamically assign Name Server Address settings. If your

ISP requires static setting of specific DNS address information, you need to receive the

following information:

• Primary DNS Address

• Secondary DNS Address

4.3 ATM Settings

The following ATM settings should be available during configuration

• ATM Virtual Path ID (VPI); Required if not using default value

• ATM Virtual Circuit ID (VCI); Required if not using default value

• Encapsulation type; Required if not using default value

• Modulation type; Required if not using default value

4.4 PPP Settings

The following PPP settings should be available during configuration of a PPP connection.

• Username (for PPP applications only)

• Password (for PPP applications only).

4.5 VoATM settings

The following VoATM settings should be available during configuration.

• ATM Virtual Path ID (VPI);

• ATM Virtual Circuit ID (VCI);

• VoDSL Signalling.

Page 9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 85 86

Pas de commentaire

Allied Data Technologies 811 Manuel d'installation Page 11