Allied Data Technologies 811 Manuel d'installation télécharger pdf (Page 26)

Chapter 5: Configuring the CopperJet

Page 24

After configuring the CopperJet in RFC1483 Bridge mode, you may need to

configure your DHCP settings on your local network card. DHCP, which stands for

Dynamic Host Configuration Protocol, automatically allocates an IP address on

your local networkcard.

5.4.1.1 Configuring DHCP on your networkcard

To configure DHCP on a networkcard for a Windows PC, follow the steps below.

1. Click the Start menu.

2. Click Settings -> Control panel.

3. Double-click the Network icon in the Control Panel window.

4. In the Configuration tab of the Network window, select the TCP/IP

component of your Network Interface Card (NIC) from the list.

5. Click on Properties. The TCP/IP Properties window appears.

6. Make sure that the Obtain IP address automatically button is selected. This

will ensure that your PC will get its IP address from your ISP via DHCP.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 48 49

Pas de commentaire

Allied Data Technologies 811 Manuel d'installation Page 26